펄스 자기장
펄스 자기장은 안테나 지지대, 접지 전도체 및 접지망들을 포함하는 빌딩과 다른 금속 구조물에 낙뢰로 발생되며, 또한 저전압, 중전압, 및 고전압 전기시스템에서 초기 과도결함에 의해서도 발생된다. 고압 변전소에서의 펄스 자기장은 회로차단기 및 고압 버스 바(bus-bars)의 스위칭에 의해서도 발생될 수 있다.
Pulse magnetic fields are generated by lighting strokes on buildings and other metal structures including aerial masts, earth conductors and earth networks and by initial faults transients in L.V., M.V. and H.V. electrical systems. In H.V. sub-stations, a pulse magnetic field may also be generated by the switching of H.V. bus-bars and lines by circuit breakers. IEC 1000-4-9-1993
펄스 주기
펄스 반복률의 역.
The reciprocal of the pulse repetition rate.
펄스 지속시간
별다른 언급이 없는 경우, 펄스의 상승과 하강구간에서 진폭이 50 % 가 되는 두 점 사이의 지속시간. (때로, 진폭의 10 % 점 사이가 사용된다.)
☞ pulse width : 펄스폭, pulse length : 펄스길이
The duration between the 50 percent amplitude points on the leading and trailing edge of the pulse, unless otherwise specified. (The 10 % ampltude points are also dften used.) MIL-STD-463A (4.139), ANSI-C63.14-1992
펄스 진폭
전자기장 세기, 전압레벨, 전류레벨 또는 전력레벨과 같은 펄스성 파라미터의 진폭. 주 : 1) 펄스 진폭은 규정된 기준값에 대하여 측정되며, 따라서 “평균값”, “순간값”, “첨두값”, 또는 “실효값” 과 같은 양들로 변경되어야 한다. 2) 또한 펄스 진폭은 주파수변조 파형의 포락선이나 위상변조 파형의 포락선 진폭에 적용되어 진다.
The magnitude of a pulse parameter, such as the field intensity, voltage level, current level, or power level. Note 1: Pulse amplitude is measured with respect to a specified reference and therefore should be modified by qualifiers, such as "average," "instantaneous," "peak," or "root-mean-square." Note 2: Pulse amplitude also applies to the amplitude of frequency- and phase-modulated waveform envelopes.
펄스 진폭 변조
펄스열 상에 규칙적인 간격을 갖는 개별 펄스들의 진폭이 변조신호의 어떤 특성에 따라 변하는 변조 방식. 주 : 진폭변조 펄스의 진폭이 정보를 전달한다.
Modulation in which the amplitude of individual, regularly spaced pulses in a pulse train is varied in accordance with some characteristic of the modulating signal. Note: The amplitude of the amplitude-modulated pulses conveys the information.
펄스 확장
펄스 지속시간의 증가. 주 : 임펄스 응답이나 실효치(rms) 펄스의 확장, 또는 최대값반치 지속시간(full-duration-at-half-maximum)펄스의 확장으로 규정될 수 있다.
An increase in pulse duration. Note: Pulse broadening may be specified by the impulse response, the root-mean-square pulse broadening, or the full-duration-at-half-maximum pulse broadening.

+ Recent posts

TOP